The 2" IPS HDPE SDR11 Poly-Cam 90 Degree Sweep is manufactured from High Density Polyethylene (HDPE) pipe. It is designed with a butt fusion end for ease of field installation. The design allows fluid to travel through the fitting with less restriction. These have an angular tolerance of +/- 4 Degrees
High-Density Polyethylene HDPE pipe
- Meets ASTM D-3350 with minimum cell classification values of 345464C (PE 3408), PE445574C (PE 4710)
- Meets ASTM F714.
- Density shall be no less than 0.955 g/cm as referenced in ASTM D1505
- Melt index no greater than 0.15 g/10 minutes when tested per ASTM D 1238
- Tensile Strength at Yield –tensile shall be 3,200 psi to less than 3,500 psi as referenced in ASTM D638
- ESCR-Environmental Stress Crack Resistance shall be over 5,000 hours with zero failures when tested per ASTM D 1693-Condition C
- All pipe meets ASTM 3035.
Dim A: 2.375"
Dim B: 5"
Dim C: 14"
Dim R: 9"